Palm Beach County only gets a handful of cold mornings a year, which is exactly why heating problems catch people off guard. You flip the thermostat to heat for the first time since last winter and the air feels lukewarm, or the system smells like burning dust, or nothing happens at all. Most homes here heat with a heat pump (the same outdoor unit that cools in summer, running in reverse) and sometimes with electric heat strips in the air handler as backup. Here are the most common reasons it isn’t heating, what you can safely check yourself, and when it’s time to call.
First: is it actually broken?
Two normal heat pump behaviors fool a lot of people:
- The air feels “cool” even though it’s working. A heat pump delivers air around 85 to 100 degrees, which feels cooler than a gas furnace and can feel chilly on your hand at the vent. If the house is slowly warming up, it’s working.
- Defrost mode. On cold, damp mornings the outdoor coil can frost over. The system briefly switches to defrost: the outdoor fan stops, you may see steam rising from the unit, and indoor air may feel cool for a few minutes. This is normal and should stop within about 10 minutes.
8 common reasons a heat pump isn’t heating
1. Thermostat settings
Check that the mode is Heat (not Cool or Auto with a low setpoint), the setpoint is above room temperature, and the fan is on Auto. With the fan on “On,” the blower runs between heating cycles and pushes room-temperature air that feels cold. Also replace the batteries if your thermostat uses them; a weak battery causes strange behavior.
2. Emergency heat (EM Heat) is on, or never used
EM Heat turns off the heat pump and runs only the electric heat strips. It heats fast but costs a lot to run, so it should only be used if the outdoor unit has failed. If your thermostat shows “EM Heat,” switch back to normal Heat. On the other hand, if you have heat strips that haven’t run in a year, the first run often smells like burning dust for 15 to 30 minutes. That’s normal. A sharp electrical or plastic smell is not; turn the system off and call.
3. Dirty air filter
A clogged filter chokes airflow, and a heat pump in heating mode is sensitive to airflow. It can trip high-pressure safeties and shut down. Swap the filter first; it’s the cheapest fix there is.
4. Tripped breaker
Heat strips draw a lot of current and often sit on their own breaker in the panel. If the strips’ breaker is off (or tripped the first time they kicked on), you’ll only get heat-pump heat, which may not keep up on a cold morning. Reset a tripped breaker once. If it trips again, leave it off and call a technician.
5. Stuck reversing valve
The reversing valve is what switches the system between cooling and heating. After months in cooling mode it can stick, so the system keeps cooling when you ask for heat. If the outdoor unit runs but the air is clearly cold, this is a likely cause and needs a technician.
6. Low refrigerant
A refrigerant leak hurts heating just like it hurts cooling. Signs include ice on the outdoor coil that won’t clear after defrost, long run times and weak heat. Refrigerant doesn’t get used up, so low charge always means a leak that should be found and repaired, not just topped off.
7. Failed capacitor or contactor
Same parts that fail in summer. If the indoor fan runs but the outdoor unit is silent, or the outdoor unit hums without starting, a capacitor or contactor is the usual suspect. Don’t open the unit yourself; capacitors hold a charge even with power off.
8. Outdoor unit blocked
Heat pumps pull heat from outdoor air, so the coil needs clear airflow. Clear leaves, mulch and plants at least two feet back from the unit.
What you can safely check yourself
- Thermostat on Heat, fan on Auto, setpoint above room temperature, fresh batteries.
- Replace the air filter.
- Check the breakers for the air handler (heat strips) and the outdoor unit. Reset once only.
- Look at the outdoor unit: is it running, and is it clear of debris?
- Give it 15 minutes in case it was in a defrost cycle.
If it still isn’t heating after that, it’s time for a technician.
Heating repair vs. replacement
Because heat pumps run in both seasons, they work harder in Florida than almost anywhere else. If your system is over 12 to 15 years old, uses R-22 refrigerant, or needs a compressor, compare the repair against a new system before deciding. Our repair vs. replacement guide walks through the math.
Frequently asked questions
Do Florida homes even need heat?
Not often, but a few nights a year drop into the 40s, and older residents, babies and pets feel it. It’s worth testing your heat in November so you’re not surprised by the first cold front.
Why does my heat pump smell like burning when I turn it on?
Usually dust burning off the heat strips after months unused. It should fade within 30 minutes. If it doesn’t, or smells like melting plastic, shut the system off.
Is it OK to leave emergency heat on?
Only if the outdoor unit isn’t working and you’re waiting for repair. Emergency heat costs far more to run than normal heat pump heating.
Can the same company fix my heating and AC?
Yes. A heat pump is your AC, so the same technician services both.
Heating repair across Palm Beach County
Cold Chillin Air Conditioning repairs heat pumps and heat strips in Boynton Beach, Lantana, Greenacres, Riviera Beach, Wellington and the rest of Palm Beach County. Licensed (CAC 1823036) and owner-operated. Call (561) 318-1882 or request service online.

